
1962-67 Nova Floor Mount Installation Instructions
For Part Number’s 2400020010
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI • PH: 517-424-0577 • FAX: 517-424-7293 • ididitinc.com
Instruction #: 8000010225 REV 12/12
Kit Includes (Figure 1):
(A.) Mount, (B.) Gasket & (C.) Clamp
Slide the gasket down the column tube, then
slide the oor mount down the columns
tube with the prongs facing the engine
compartment. Align the oor mount & gasket
with the original mounting holes in the oor.
Install the 4 bolts with the large washers to
secure the oor mount to the rewall. From
inside the engine compartment, slide the
clamp around the two tabs of the oor mount
& the column. Simply tighten the clamp to
secure the column to the oor mount.
(Figure 2 & Figure 5)
The lower interior rubber trim piece (Figure
3A) will have to be modied as there is
no way to slide the grommet into the oor
mount. Interior Rubber Trim Piece: This
piece is an original part of the vehicle. If
one was not provided with your vehicle,
follow our Source Guidance below. Figure
3B shows the nished part trimmed and
ready for installation. Install the trim piece
loosely. To secure it, put a dab of silicone or
trim adhesive on the inside where it meets
the column. You may want to put a piece
of tape around the grommet for 24 hours or
until it dries. Figure 4 shows the trimmed
part properly installed.
*PLEASE NOTE: The enclosed oor
mount has a “hot dip” black oxide
nish. It would be important to put a
permanent nish on it before you install.
1962-66 Screw Size: 1/4” screw, 3/4” long,
#10 thread & no washer
1967 Screw Size: 1/4” screw, 7/8” long,
#14 thread & 1” washer
Rubber Trim Piece: Found on nnnova.com
Source Guide:
Comments to this Manuals