Ididit Floor Mount: Collapsible Floor Mount User Manual download pdf

PROPERTY OF

ididiT, inc

PROPERTY OF

ididiT, inc

PROPERTY OF

ididiT, inc

PROPERTY OF

ididiT, inc

PROPERTY OF

ididiT, inc

PROPERTY OF

ididiT, inc

ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: 517-424-7293

www.ididitinc.com

Collapsible Floor Mount Installation Instructions

For Part Number’s 2401010010, 2402010010, 2401110010, 2401210010

Instruction #: 8000010252 REV 04/14

This oor mount is designed to mount a steering column to the oor

or rewall and can be installed on either side of the body.

(Figure 1)

1. Choose the location of the mount. This should be a at surface

that the mount can seal against. Note: The mount can be rotated

in any direction. Cut out the provided template and use it to help

determine where the mount will be located. Use a punch and

mark the three locations indicated with the X on the template.

(Instruction # 8000010498, 8000010499, 8000010500 or 8000010501)

2. Use a ¼ inch drill bit and drill the two outside holes. We

recommend using a hole saw to cut the center hole. A ¼ inch

hole in the middle will guide the hole saw also.

NOTE: There are four different sizes available for these mounts. If

you have a 1 ½ inch tube use a 2 inch hole saw; a 1 ¾ tube will use

a 2 ¼ inch hole saw; a 2 inch tube will use a 2 ½ inch hole saw; and

a 2 ¼ tube will use a 2 ¾ inch hole saw.

3. Slide the rst metal plate onto the bottom of the steering column

tube with the ange facing the top of the column. Next, slide

the O-Ring onto the column followed by the second metal plate

with the ange facing downward. The last piece to be slid onto

the column is the gasket. Slide the gasket over the end of the

tube. (Figure 2)

4. Install the column through the oor of your vehicle while

retaining the order of the oor mount pieces. The oor mount

(with the seal down) should match the holes you have cut.

5. Use the provided hardware to secure the oor mount to the oor.

Slide 1 at washer and 1 lock washer on each of the bolts and

thread the bolts through the holes on the oor mount. These

bolts are to be torqued at 11 ft. lbs. (Figure 3)

6. Your installation is now complete!

*PLEASE NOTE: The enclosed oor mount has a “hot dip” black oxide

nish. It would be important to put a permanent nish on it before you

install.

(See NOTE for appropriate size)

REV 04/14 1

Summary of Contents

Page 1 - REV 04/14

PROPERTY OFididiT, incPROPERTY OFididiT, incPROPERTY OFididiT, incPROPERTY OFididiT, incPROPERTY OFididiT, incPROPERTY OFididiT, incididit inc. 610 S

Comments to this Manuals

No comments

Ididit Floor Mount: Collapsible Floor Mount User Manual

Browse online or download User Manual for For the car Ididit Floor Mount: Collapsible Floor Mount. ididit Floor Mount: Collapsible Floor Mount User Manual [de]

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Ididit Floor Mount: Collapsible Floor Mount